: ✯ : Flashing by VU + Util : ✯ :

sunsong
Registered Member
Registered Member
Posts: 144
Joined: 19 Jun 2013, 7:13 pm
Location: Mauritania

: ✯ : Flashing by VU + Util : ✯ :

Post by sunsong » 04 Dec 2013, 3:54 am

Start The Flash tool VU + Util

Image

Select your COM Port

Image

Deselect DHCP if you have not setup IP VU + duo

Image

Then click on Connect button

Image

Now you should see Serial port open Please turn on your box.

Do this with on power switch For Ethernet Flash Tick DHCP is set next Click on Set IP button and enter your IP

Image

Now youll see "IP Setup Success" in the VU + Util

Image

Click open and select your NFI image file.

Image

Press the flash Button

VU + Util then says "Reading file, please wait a moment ..."

Image

Wait till you see flashing process is completed

Image

Now the update is finished and you can disconnect and then finish with a Click on the Exit button VU + Util.

Now power off then on.
Image

User avatar
-=UMARZAIN=-
Contributor
Contributor
Posts: 1491
Joined: 11 Dec 2013, 10:53 pm

Re: : ✯ : Flashing by VU + Util : ✯ :

Post by -=UMARZAIN=- » 14 Dec 2013, 3:29 pm

:thank: GREAT WORK BROTHER, VERY HELPFULL

Post Reply Previous topicNext topic