TP-LINK Access Point TL-WA5210G Detail

User avatar
FARRUKH
Moderator
Moderator
Posts: 9502
Joined: 18 Dec 2014, 9:02 pm
Location: Rawalpindi Pakistan
Has thanked: 331 times
Been thanked: 1114 times
Contact:

TP-LINK Access Point TL-WA5210G Detail

#1



Post by FARRUKH »

Access Point TP-LINK TL-WA5210G
Image
General view

Image
Rear view

Image
View of the connectors

Image
The included accessories

Outdoor access point TL-WA5210G High Power 2.4 GHz is dedicated for Wireless Internet Service Providers (WISPs). Wireless data transmission can be performed in AP, AP Router, WISP, or WISP Client mode. The device is equipped with a high gain antenna, which, together with the electronic board, is put in a weather-resistant housing. Thanks to the antenna with 12 dBi gain, high output power of the transmitter (27 dBm) and high sensitivity of the receiver, the device allows to create long-range, stable and efficient wireless connections.

Distinguishing features:
High efficiency and Tx output power - 27 dBm,
High Rx sensitivity - 54M: -76 dBm,
Directional 12 dBi antenna,
Weatherproof housing,
ESD protection - 15 kV,
Support for AP , WISP and AP Router modes,
PoE (up 60 m via UTP cable),
Simple and quick installation,
Wireless transmission speed up to 108 Mb/s (turbo mode),
Transmission range up to 15 km,
Vertical or horizontal polarization,
Second layer isolation of subscriber traffic,
Information on current speed,
PING watchdog,
Speed test,
Remote management,
Support for WEP, WPA/WPA2,WPA-PSK/WPA2-PSK,
SMA R/P connector for an external antenna.
TL-WA5210G N2350 can operate as:
Router Client (WISP),
AP Router,
Access Point,
Client, WDS Bridge,

Some operation modes:
Image
Client Router (WISP) mode

Image
Point-to-Point mode

A typical point-to-point link can be achieved by a combination of the device working in Access Point mode and another device operating in Client (or WISP Client) mode, or by a pair of devices operating in Bridge mode. The connection enables data transmission in both directions between two locations. Use of Access PointandClient, or Bridge modes makes a "transparent connection".


If needed, the additional mount E9263 allows to adjust tilt of the device.
Image
TL-WA5210G N2350 installed on a mast with the optional bracket E9263
Image
Mediastar MS-Diamond X2 Full 4K
TCL 40" UHD Smart LED Tv
Shabbir 8ft A Quality Motorized
Covering 3.1E to 122E
My Motorized Dish
Hotbird Scan Result
Badrsat Scan Result
Kontinent Scan Result
User avatar
-=KASHIF=-
Registered Member
Registered Member
Posts: 245
Joined: 28 Oct 2014, 1:12 pm
Location: HAROONABAD
Has thanked: 3 times
Contact:

Re: TP-LINK Access Point TL-WA5210G Detail

#2



Post by -=KASHIF=- »

flash bricked ho gaye to koi solution ha es ka ?
Post Reply Previous topicNext topic

Who is online

Users browsing this forum: User avatarApple and 41 guests