chazer wrote:It seams that lcd picks some kind of interference through it's input sources. What about when you watch something through usb ,does it fliks
yea it is sure ,LCD picks interference and only we need to sort out that kind of interference
I didn't do any practice yet ,watching something thru USB.
thanks once again for sparing time
DM 900 UltraHD 800HDse SIM2.10 OpenBox AS4K CI Pro
chazer wrote:So haven't you checked yet with USB ??
OH sorry I didn't know you were waiting for such kind of observation
BTW I don't have same issue since last many days ,might be line's voltage losses have been recovered by LESCO
anyhow I'm thankful to you for your kind efforts
DM 900 UltraHD 800HDse SIM2.10 OpenBox AS4K CI Pro
yes the problem has gone till voltage drop
I had managed a servo motor stabilizer (ST500WS model of STAC company) to solve my issue but one responsible member of the board awared me by using such device consuming 500 WATTS out of 1000 Watts UPS so I accepted his genuine proposal otherwise I would destroy my UPS
DM 900 UltraHD 800HDse SIM2.10 OpenBox AS4K CI Pro
@chazer!!!
congrats for being a part of admin team
few days earlier I got chance to check with Homage Inverter and LCD was working fine during load shedding
your arguments in above posts were 100% accurate.
the only one issue remains i,e as the WAPDA power goes OFF LCD goes to reset ....may be due to old battery ?
DM 900 UltraHD 800HDse SIM2.10 OpenBox AS4K CI Pro
Sorry, don't know how i missed that, infect didn't thought of an old thread might get alive, sorry again.
Now coming to the issue ,it's due to increased transfer time of the UPS. Homage typical transfer time is 15~30ms and it increases with the applied load and battery condition.
One possible solution is to add an old Desktop ups, it's backup time is just 5~10min, sufficient to suppress glitch produced by Homage. These are usually of 200~400watts online type with 0s transfer time and cheaply available at computer shops.
Secondly thanks for the compliments.
Regards.
couldn't find thanks button ,so paying in writing .....THANKS for sharing information.
I'm sorry as well
by the way I re-installed my desi UPS after an experimental check
DM 900 UltraHD 800HDse SIM2.10 OpenBox AS4K CI Pro
Just got my emulator III from the States and forgot to switch the power supply to 220VAC... does anybody have a an electrical blueprint of that baby???
Few days earlier I had a 40 LCD Sony Bravia which was sold by me and then came back after one and half years....normal chinese box or DM 800/800HDse had been working for a long time ..as I connected my DM 900 ,no display on screen "unsupported signals" message appeared on screen ...I connected DM 900 SIM2.30 and same result ...should I need to replace LCD with LED or some thing wrong with particular LCD
DM 900 UltraHD 800HDse SIM2.10 OpenBox AS4K CI Pro