Sun hd horizental tps

OmMeE
Registered Member
Registered Member
Posts: 167
Joined: 22 Feb 2017, 2:47 pm
Has thanked: 2 times
Been thanked: 1 time
Contact:

Sun hd horizental tps

Post by OmMeE » 04 Apr 2018, 9:39 pm

ali03000345 wrote:
04 Apr 2018, 7:32 am
mujhe confirm to nahi lakin Focus main KU band nahi C-band lnb ati hai aur KU k liye aaj kal log inverto black ultra use krte hain around 1500 milegi
Inverto black ultra for Karachi is usually used for hard reaching satellites to get maximum signals. E.g. 88E, 13E, 7W, etc.

And KU mei focus aati hai.

ali03000345
Registered Member
Registered Member
Posts: 493
Joined: 15 Dec 2017, 9:21 am
Has thanked: 2 times
Been thanked: 3 times
Contact:

Sun hd horizental tps

Post by ali03000345 » 05 Apr 2018, 7:15 am

aap keh rahe hain to zaroor ati hogi main ne daikhi nahi is liye kaha k confirm nahi wese 88, 7 to ajate hain normal per bhi han 13 k liye inverto use ki jati hai woh bhi is liye k ziada bari dish na lagani pare

niceabi
Registered Member
Registered Member
Posts: 239
Joined: 19 Aug 2014, 10:49 pm
Contact:

Sun hd horizental tps

Post by niceabi » 09 Apr 2018, 9:57 pm

OmMeE wrote:
04 Apr 2018, 8:50 pm
niceabi wrote:
03 Apr 2018, 9:39 pm
focus brand lnb is good or Lazer?
Lazer is better. I have Focus and Lazer and for satellites such as SUN HD, Dish tv, Videocon, ETC. Focus is MOOOORE than enough.

Focus costs Rs.350 in Karachi and Lazer is above Rs.1500. I bought it for Rs.1700.
I have lazer lnb

usamafalak
Junior Member
Junior Member
Posts: 16
Joined: 02 Apr 2018, 12:11 pm
Been thanked: 1 time
Contact:

Sun hd horizental tps

Post by usamafalak » 10 Apr 2018, 10:13 am

Check the basic setting on your receiver side
in antenna setting select both 13/18 V
connect lnb directly without diseqc switch and then scan you should get signal on both horizontal and vertical tps

usamafalak
Junior Member
Junior Member
Posts: 16
Joined: 02 Apr 2018, 12:11 pm
Been thanked: 1 time
Contact:

Sun hd horizental tps

Post by usamafalak » 10 Apr 2018, 10:18 am

if this doesn't work then select the horizontal tp and check the voltage on the cable output, it should be 18v for horizontal and 13v for vertical.

Post Reply Previous topicNext topic