Many friends are facing problem in watching the videocon using Oscam or Oscam Emu. Here is the solution.
If you want to watch videocon through sharing using Oscam or Oscam Emu, you may do so by enabling "Skip CWs checksum test" setting in "Cam Reader Config".
To do this follow these steps:
1. Access "Oscam WebIF" by typing following command in any internet browser on PC or laptop (your receiver and PC should be connected to the same network for this):
BOXIP:8888
3. When WebIF opens, click on "Reader" tab at the top.
4. On next page click on the appropriate reader (in which your cline or nline is added), under "Reader" column to open Reader config page.
5. Scroll down to the middle of the page where you will see "Skip CWs checksum test" checkbox. If it is unchecked, check this (place a tick mark by clicking on the box).
6. Go to the bottom of this page and click on "Save" button to save this change.
7. Restart the oscam, after a couple of seconds the channels will start opening.
To have more clarity see following screenshot.
Watch Videocon Using Oscam or Oscam Emu
- engineerkhan15
- Registered Member
- Posts: 362
- Joined: 05 Sep 2013, 4:51 pm
- Has thanked: 5 times
- Been thanked: 141 times
Watch Videocon Using Oscam or Oscam Emu
Zgemma H5 Combo (DVB-S2 & DVB-C/T2) Enigma2 Receiver
Vu+ Solo SE V2 Enigma2 Receiver
KI Pro 4K Android/Enigma2 Combo (DVB-S2 & DVB-C/T2) Receiver
Amiko Alien 2 (Spark7162) Dual Boot Receiver
Starsat SR-2000 HD Hyper
6 Feet Eurostar Dish
Vu+ Solo SE V2 Enigma2 Receiver
KI Pro 4K Android/Enigma2 Combo (DVB-S2 & DVB-C/T2) Receiver
Amiko Alien 2 (Spark7162) Dual Boot Receiver
Starsat SR-2000 HD Hyper
6 Feet Eurostar Dish
Who is online
Users browsing this forum: Amazon [Bot], Apple, Claude, Dot, facebook, Google Adsense, jackwilliam23, Petal and 3 guests