Golden Multimedia Forum

What brand of UPS you are using, is it local made or imported and lastly output is square,sine or modified sine wave ??
here lies the point ...it is local NOT branded or imported and out put is square. :-|
So it produces square wave, that is not recommended for delicate electronic equipment. At ...

Few days earlier I purchased one 40" Sony LCD BX400 from OLX in Rs.35000 ...I'm facing a problem as 32 goes it remains OFF whereas my other LCDs remain ON (as UPS used to take over) but this LCD doesn't work with UPS power.
Is there a protection in this model which prevents to withstand with UPS ...

Dear Masood, Thanks for the compliments, I am just an ordinary person with a little knowledge of Electronics and love to help.

Regards.

@chaser!!!
as you suggested in another thread that till dish's stand level is not even to the surface ,the signals access may not be possible.
Normally when I use to access any sat I keep my position behind the dish while inclining/declining slightly and it makes no effect of even or uneven surface ...

Salam dear all friends and forum members plz help me mujhe ARC angle bare me kuch pta nhi hai so plz help karen or ke Arc angle kese banta hai mere pass auto positioner or motor 18 inch vala or shahbbir 8feet hai mere pass dual feed horn jis me centre C band hai side Ku band hai mere location ...

Dear Masood, by looking your LNB i suggest these steps.
1, Place adjustment ring in the center of adjustment space.
2, Measure the distance between feed entering point and center of the dish, and if it is equal to the focal length then all is ok and your feed is at the focal point.
3, If the ...

Dear Masood, no need to decrease the length of the supporting rods , you know the focal point calculated from formula is theoretically 100% correct but physically not. What i meant to say it is not possible to manufacture an ideal Dish. There are minor dents on the surface and also curve of the ...

One more thing first calculate the focal length of the dish with the formula given above in this thread.

Dear Masood i already described the procedure for determine the length of supporting rods in my post above. Let me explain a little bit more, Top of the stick means position of the feed horn from there you measure the length with the help of inches tape to the point where you want to fix the ...

I forgot about screw holes, for that add about 3 inches to the measured length. Bend the rod 1.5 inch from each side for the holes. The picture explains.