Golden Multimedia Forum

Perhaps also 108E Airtel

The reason behind this is Local oscillator freq witch changes from 9.75GHz to 10.60GHz on detection of 22kHz in Universal type KU LNB and this function perform by the receiver autometically.If other Tps of above 12GHz faces the same problem then it could be due to lac of 22kHz signal approaching ...

Auto walay pay all frequency ok received hoti hain jab k on walay saari received nahi hoti
Itni tafseel batanay ka maqsad ye hai k app 22khz ko auto kar k dekhoo

The reason behind this is Local oscillator freq witch changes from 9.75GHz to 10.60GHz on detection of 22kHz in Universal type KU LNB ...

Mera pas ye meter nahi ha
I think you already checked the receiver and if it is ok then it must be due to length or poor quality of the cable used, if it is RG6 then switch to RG11 witch has low resistance.
If you ask some tech guy to find the voltage drop for you then may be i can suggest some ...

-=UMAIR=- wrote:

M Hassan wrote:

M Hassan wrote:umair bhai agr dish size maloom krna ho to kis tarah maloom karen gay mtlb aik side se dosri side ya aik side se depth mein?

to be honest i have no idea on this waise aik side se dausre side wala mujhe lagta hai

Yes.( aik side se dausre side).

To check the voltage use this setup and this test must be done at the LNB end with LNB attached.

I have connected ku lnb directly with the receiver but no results missing H tps.
It mean the fault is either due to long cable or faulty receiver witch can be checked by using a short cable as i said earlier in my replies.
One more thing did you check the voltage at the end of the cable with LNB ...

I have tried it by removing powerpass but it doesnot work it miss the same H tps in ku lnb
It's not a matter of 2 or 4 receivers it is the working of powerpass vs multiswitch. For example S.S Cband is connected to two receivers with powerpass along with other KU LNBs through Diseqc switch, And if ...

It depends, if the issue resolves after removing powerpass splitter then I recommends multi-switch for splitting S.S cband and other simple cband LNBs signals. Use 2X4 type multi-switch witch can connect to 4 receivers ,for each LNB use separate switch and if you want to connect dual KU LNB to 4 ...

Only one S S c band lnb and two non S S c band lnb(sadi wali ) and two ku lnb which has two output.
Two diseq switch one is of 8 in 1 and second is 4 in 1
And one powerpass 2 output wala
In first diseq(8 in 1) i have connected 1 S S and
one non S S( sadi lnb) and two ku lnb
Second diseq(4 in1 ...