Help for xtrend et9000

[moonji54]

Dear experts from last night my xtrend et 9000 stop booting. When I switch on the receiver only power button light blink blue. Nothing showing on led. I tried to reflash but not booting from USB too

[Aliraza63]

Dear experts from last night my xtrend et 9000 stop booting. When I switch on the receiver only power button light blink blue. Nothing showing on led. I tried to reflash but not booting from USB too

If u have installed HDD any other usb hdd remove it and try to install again firmware

[moonji54]

no there is no HDD or USB attached, my TV also gone dont know the reason.even here no issue with light or power socket. tv gone but receiver was working that time but from last night receiver stop booting.

[Aliraza63]

What do u mean by tv gone ?
if there is no any hdd connected then it must be the power supply fault . check the power supply measure its volts with voltage meter .

Updated : Relax and check . dont forget to remove all cables like lan , lnb , usb , hdmi , av .then power on and check
Sorry I am leaving HM on line we are busy in operation to My newly bought DM 7020HDv2 . but leave msg here I shall further guide u tomarrow. AH

[moonji54]

dear ali brother, the day before yesterday first TV stop working, it was showing red screen means some TV hardware gone but that time receiver was ok. after that i change the power supply extension. but from last night receiver too stop working. i dont have tool to test means need to visit dream multimedia show room. hope will not cost more.

[Masood]

@moonji
If you are using HDMI cable for video output ,TV may damage attached box or vice versa in case any of those is malfunctioning. Did you remember Furrukh's incident ? both things TV and box got burnt. He told the same situation.
Box can be fixed by Aliraza I'm sure but TV can be repaired by a TV mechanic.

[Aliraza63]

dear ali brother, the day before yesterday first TV stop working, it was showing red screen means some TV hardware gone but that time receiver was ok. after that i change the power supply extension. but from last night receiver too stop working. i dont have tool to test means need to visit dream multimedia show room. hope will not cost more.

. In VU+ and Extrend main boards there are protection circute working . psu sends 5v separately to hdmi hub and returns its signal which enables the hdmi. u can say it works like switching between main boards . on the other hand in DM CPU sends the 5 volt to enable the signal of HDMI .which is opposite against protection . In short I dont think so it will be a major disaster in STB . may be I am wrong but in my point of view is 90% have power supply fault. as u have mentioned u dont have tool kit and dont have enough knowledge . I shall suggest u to vist DMM shop .

[Masood]

in my point of view is 90% have power supply fault

ur observation is 100% correct according to my experience.
If it is repaired over here from Hall road it may cost 3 to 400 rupees.

[moonji54]

Yes it could be due to hdmi cable. I given my no to dream multimedia Dubai for repair box is under warranty and hope will not charge

[Masood]

Glad to know moonji !!! ur box is under warranty .
by the way Aliraza explained technically ,deserves for more thanks