Attention For StarMax G-Share Box Users !!!

[Dr.Timor]

-Don't Upgrade your STB With new Official Softwares if you updated with new patches then you can't back to Previous version even with flash programmers .

- In the new Software CCcam ,Newcamd protocol removed .

-Use only 23- 01 -2017 Release .

[suleman84]

Lo Je Ab Hum Box Ke Sath Panga Be Ni La Sakte....ager Box ke offical Sotware Aye to Per to kye issue ni hona caye..

[Dr.Timor]

Lo Je Ab Hum Box Ke Sath Panga Be Ni La Sakte....ager Box ke offical Sotware Aye to Per to kye issue ni hona caye..

Problem hy problem Agar box achanak boot stuck bhe hogaya flasher ke saat bhe recover nahi hoga kyu k es ke chip 16Mbyte hai jo flash programmer bazar meh hai wo sirf 8mb tak ko flashing karta hai .

[kusakhan]

only new version STB....Not old boxes Like A20....

[Dr.Timor]

only new version STB....Not old boxes Like A20....

yes only 3511 & 3516 will be recover but i'm not sure with PC loader

[addan1]

i have already done that my bad luck but i have previous version so i revert back to old but now its show me only 40 number server which i can edit or add all other all disable in new update there is a only 1 server shows is there any other way to revert back and active all other server enable ???

[Dr.Timor]

i have already done that my bad luck but i have previous version so i revert back to old but now its show me only 40 number server which i can edit or add all other all disable in new update there is a only 1 server shows is there any other way to revert back and active all other server enable ???

Only me fix this issue .

[Umair Malik]

i have already done that my bad luck but i have previous version so i revert back to old but now its show me only 40 number server which i can edit or add all other all disable in new update there is a only 1 server shows is there any other way to revert back and active all other server enable ???

If 40 no server is opened
Then goto 40 number server
Copy the 40 number server than go to server number 1 paste the server number 40 on it now disable the server and then delete it now enable the server server number 1 it will be decrypted now.

This worked well on tiger t800 hd with me

[Dr.Timor]

i have already done that my bad luck but i have previous version so i revert back to old but now its show me only 40 number server which i can edit or add all other all disable in new update there is a only 1 server shows is there any other way to revert back and active all other server enable ???

If 40 no server is opened
Than goto 40 number server
Copy the 40 number server than go to server number 1 paste the server number 40 on it now disable the server and then delete it now enable the server number 1it will be open now.

This worked well on tiger t800 hd with me

Tiger ne CCcam aur newcamd ko remove nahi keya only starmax per ye kaam howa hai past vast se kuch bhe badal ne wala nahi hai new software per only orginal gshare hai TAMAM !

[yousif.m.pk]

Timor Bhai gshare-3 aur gshare-4 kia ye dono same hen ?aur in k pkgs bi same hen ya nahi ???aur gshare-3 kitni price me recharge hoga ??aur pkgs konse open honge ????