How to setup Vu+ with VBox II DiSEqC 1.2 Positioner.

User avatar
sakisvele
Moderator
Moderator
Posts: 20906
Joined: 18 Jun 2013, 12:48 am
Location: 💥] ✅ Europe 💥] ✅
Has thanked: 52 times
Been thanked: 481 times
Contact:

How to setup Vu+ with VBox II DiSEqC 1.2 Positioner.

#1



Post by sakisvele »

How to setup Vu+ with VBox II DiSEqC 1.2 Positioner.
Positioner_VboxII_1.jpg
If your VBox II already has the satellite positions stored and your changing from an old receiver to Vu+ then follow this procedure.


Write down your VBox II satellite position numbers. These are the numbers displayed on the front of the VBox II when moving to a
specific satellite position. These position numbers can also be found in your old receivers motor setup menu. Or FTP to /etc/enigma2/settings.



Example lets say...
Position 1 on VBox II = Astra 19e
Position 2 on VBox II = Eutelsat W2 16e
Position 3 on VBox II = Hotbird 13e


You get the idea...


First send the dish to Astra 19e using Vbox II.


On Vu+ Remote Press Menu
Select Setup Press OK
Select Service Searching Press OK
Select Tuner configuration Press OK
Select Tuner A Press OK


Now set Configuration Mode to Advanced. Use Left or Right keys on remote to select.



Code: Select all

   Configuration Mode: Advanced
    Satellite: Astra 19e
    LNB: 1
    DiSEqC mode: 1.2
Scroll down to botton of the page with the down arrow on remote.


Stored position: 001


Press OK to store.


OK that's Astra 19e setup now to setup Eutelsat W2 16e


Now send the dish to Eutelsat 16E using Vbox II.


Select Setup Press OK
Select Service Searching Press OK
Select Tuner configuration Press OK
Select Tuner A Press OK


Code: Select all

    Configuration Mode: Advanced
    Satellite: Eutelsat W2 16e
    LNB: 2
    DiSEqC mode: 1.2
Scroll down to botton of the page with the down arrow on remote.


Stored position: 002


Press OK to store.


OK that's Eutelsat W2 16e setup now to setup Hotbird 13e


Now send dish to Hotbird using Vbox II


Select Setup Press OK
Select Service Searching Press OK
Select Tuner configuration Press OK
Select Tuner A Press OK


Code: Select all

    Configuration Mode: Advanced
    Satellite: Hotbird 13e
    LNB: 3
    DiSEqC mode: 1.2
Scroll down to botton of the page with the down arrow on remote.


Stored position: 003


Press OK to store.


You get the idea, now repeat for the rest of the satellites and your done.


This is enough to get you started, the fun starts learning the rest.

thnx @master G

Who is online

Users browsing this forum: No User Avatartrendiction and 48 guests